Pages: 1 Introduction 2 Filter Assembly Box 3 Fans 4 Smoke Alarm/Power Stop/Automatic Fire Extinguishers 5 Temperature Controllers 6 Heaters 7 Enclosure Material Options 8 Alternative Filter Assemblies/Ventilation Unit 9 Motherboard Fan Modifications for Bambu Lab A1 10 Various DIY Enclosures 11 My Enclosure
The final test of the solar oven for this year was performed yesterday, Saturday, October 22, 2022. Trials will begin again next year, in early summer. The highest oven temperature reached yesterday was about 142° Fahrenheit. That is more than 20° below the temperature from the last test (see video). The trials take place on…
The idea for this jewelry box was spawned by Instructables’ organization contest. I decided not to enter the contest before I finished as not many instructions are needed to put the box together. Instructions are necessary for modeling the individual boxes and it was too much to explain, simply. I used Blender and Tinkercad for…
The frame is almost together. The roll of filament I ordered on Sunday arrived yesterday. I have three more parts to print for the bottom. However, I do not have enough hardware to finish putting the parts together. I ordered more yesterday and hopefully it will arrive before the end of next week. I wanted…
We determined the best candidate 3D printing material and infill geometry from this analysis, Essentium PLA Gray filament and “grid” infill, respectively, and printed standard surgical Army-Navy retractors to test the mechanical strength of PLA following annealing and autoclaving interventions, both independently and together. Standard and strength-optimized Army-Navy retractor designs created by Chen et al….
I have wanted a hamper stool for quite some time now. I failed to find one I wanted to buy, so I designed one for myself. The render above shows how I imagined it will look. However, today I changed my mind. I was 3 hours into a 10 hour print on my Prusa clone…
It has been a little over 2 years and the chair design I was close to printing has not been printed. I was having difficulty trying to figure out how to prevent the chair from collapsing in the middle. My goal was to have an entirely 3d printed chair that could be printed on a…
