Light Pillar, indoor and outdoor solar lamp, 3d print.

Light Pillar

Light Pillar, indoor and outdoor solar lamp, 3d print.

Light Pillar, with the addition of solar replacement light disk, becomes a game-changer. You can enjoy the convenience of outdoor solar lighting indoors. No more manual adjustments. Simply place it near a window that gets direct sunlight and let the sun do its magic. You will be able to Illuminate your space with the same natural beauty as an outdoor solar light.

The column is 15.7 cm tall and holds solar replacement lights that have an outer diameter of about 8.5 x 8.5cm (3.35 x 3.35 inches) and an inner diameter of about 7.5 x 7.5cm (2.95 x 2.95 inches). Here is a link to the solar replacement light I used. I have personally tested the light and found that it can charge indoors when it is placed up to 30 inches from a window receiving direct sunlight.


Author

Similar Posts

  • |

    Abstract Montage

    Celebrating Geometric Beauty in a Modern Way This 3D-printed setup is all about giving classic geometric shapes a fresh, modern twist. Inspired by the clean lines and bold vibes of contemporary design, the prints come to life with a tactile edge thanks to 3D printing. The rhombus-shaped frames are arranged in a way that’s totally…

  • |

    Flow Vase

    This contemporary vase features a design characterized by vertical rounded folds that run from top to bottom. The gentle folds reinforce its structural integrity, making it both beautiful and practical in addition to evoking a sense of movement.   The vase was made using Make My Vase software.

  • |

    Tracs Bowl

    Tracs bowl was one of the models made from experimenting with the Make My Vase software on Maker World’s website. I wanted to know if the software simplified modeling swirls and found that it did. The bottom portion of the bowl consists of closely aligned, twisted swirls while the top portion is formed by tightly…

  • Solar Oven Year End

    The final test of the solar oven for this year was performed yesterday, Saturday, October 22, 2022. Trials will begin again next year, in early summer. The highest oven temperature reached yesterday was about 142° Fahrenheit. That is more than 20° below the temperature from the last test (see video). The trials take place on…

  • Sunara Table Lamp

    This is another model designed using Make My Vase software on Maker World’s website. I finished the design in Blender and 3D Builder softwares. The white shades hold removable solar discs that can be charged on a windowsill, providing cordless, sustainable illumination. The shade was printed in vase mode using Inland High Speed Silk PLA…

Leave a Reply

Your email address will not be published. Required fields are marked *